I attached pic below of where I have the pointer started in TP1 mode, what the display is reading after the second mark scan and a pic of my setting for the marks.
04' and there is at least 2' border for the pinch rollers. The actual print is only 18' across on 24' media and about 15' long. the first one got detected but when it went to read the second I got a Error Mark Detect with the B flashing and (1-3) = 476.7. I was originally using Type 1 registration marks with no luck then switched to type 2. My issues are when I go to contour cut I get a Error 36 Mark Detect. I have no problems getting regular plotted vinyl to cut and the plotter is cutting nicely. I'm using a Mutoh VJ 1204 to print with and have Wasatch 7. This plotter is at my house and not set up with my other equipment. To start off, I design in Corel 2017 and use FineCut 8 to generate the registration marks and plot. I've really tried reading the manual but it's a bit confusing so I'm hoping I can get a few pointers from those of you that use one of these. At the time it was in service his employees were the ones operating the plotter so he doesn't know much about it and he is a one man shop now. He's switched directions in his business (installations only) and no longer needed the plotter. I recently bought a Mimaki CG-130 FX plotter from a friend for a good price and figured it would be a good extra plotter.
